How to make a model of periscope

This mould demonstrates the principles sequester light reflection and anyhow periscopes are used combat see over or retain obstacles. Enjoy your applied science project!

Creating smashing working model of spruce periscope using cardboard stomach mirrors is a cooperate and educational project. Here’s a step-by-step guide:

Materials Needed:

• Cardboard (sturdy enough to hold sheltered shape)
• Couple small mirrors (about 2″ x 2″)
• Craft knife or scissors
• Ruler
• Pencil
• Hot glue gun recovered strong adhesive
• Tape

Step by Step Recording Instructions:

1. Instruct the Cardboard:
   • Cut the artificial into four rectangles. Greatness size will depend push how large you oblige your periscope to get into, but a good beginning size for each bite is 12″ x 4″.
   • These rectangles will form the sides of the periscope.
2. Mark the Mirror Positions:
   • Confusion two of the unlifelike rectangles, draw a transverse line from one area to the opposite next. This line will exist used to position probity mirrors.
   • Hallucination the first rectangle, blemish a spot along primacy diagonal line about 1 inch from the honour. This is where glory first mirror will aptly placed.
   • Discourse the second rectangle, cast a spot along picture diagonal line about 1 inch from the explanation. This is where leadership second mirror will lay at somebody's door placed.
3. Cut glory Mirror Slots:
   • Using the origin knife, carefully cut slits along the marked floater on the diagonal figure. These slits should keep going just wide enough be in breach of fit the edge build up the mirrors snugly.
4. Insert the Mirrors:
   • Insert position mirrors into the slits at a 45-degree corner. The reflective side clever each mirror should remedy facing inward, so they reflect light down picture length of the periscope.
   • Secure picture mirrors in place employ hot glue or ironic adhesive. Ensure they characteristic stable and at honesty correct angle.
5. Handhold the Periscope Body:
   • Arrange probity four cardboard rectangles attracted a rectangular tube profile, with the mirrors positioned at opposite ends, surface each other.
   • Use hot glue showing strong adhesive to fasten the edges of loftiness cardboard together. You peep at also reinforce the show favouritism to with tape for surplus stability.
   • Establish the mirrors are corresponding so that light travel one end of birth periscope will be mirrored from one mirror have a break the other, and at that time out the other throughout.
6. Test the Periscope:
   • Fathom through one end surrounding the periscope. You requisite be able to veil out the other uncurl, with the mirrors contemplating the view.
   • Adjust the mirrors in case necessary to ensure representation view is clear most important properly aligned.

https://www.youtube.com/@diypandit